Monday, September 12, 2016

Hands-on Review on Clover 15mm Throw Dual Action Polisher

This is a review of my 15mm dual action polisher. You can read about the unboxing and initial impressions here.

After much procrastination, I decided to re-seal my daily drive. I used the new DA with the included green pad. It is a medium cutting pad which is ideal for an all in one polish. Before starting, I was dilly-dallying to use either Autoglym Super Resin Polish (SRP) or Dodo Juice Lime Prime. Then, while doing a walk-around, I noticed some very minor scratches on the sides of the car, maybe due to some brushing from twigs. This is what we usually get, parking by the roadsides. To remove and fill those scratches, I went on with SRP that has some fillers in it.

Straight on, the DA works as it should have with well-controlled vibration. My hands did not feel as numb as with Bosch GEX. Cutting power with the supplied green pad was good. See the condition of the pad after polishing the roof top. This is after washing and claying.

One thing to note is that this DA is quite loud. It is louder than my old Bosch GEX. I had to use my wireless headphone with active noise cancellation to seal off and cancel off the noise. See that headphone hanging on the top of the chair? That headphone sealed off about 70% of the noise. Do take this with a pinch of salt though as I am not an audio expert. This was merely based on feelings. Luckily my neighbors were not in. Although it is loud, I am guessing it would be the same with other DA's. I read on the Internet that DA's tends to be loud :-p

Another point to take with this DA is that it tends to get quite hot especially near the top. It could get a little uncomfortable. I should have used the provided handle. I was working with this for about an hour or so (on and off in between wiping panel by panel) and the temperature sort of maintained at the same level as when it first ran in the first 15 minutes. So, not a deal breaker.

And as with larger throw DA's in general, getting into tight spot is a little difficult compared to smaller throw DA. Here, at the rear bumper, I could only get this to polish near the outer edge. Any closer, the side of the pad would hit the panel. With my old GEX I could get much closer. I had to use hand polish for this area. Luckily I went for the 15mm throw, a 21mm throw would not even go in, I think.

All in all, this DA works great and is really worth buying. The pads stayed very well throughout the whole polishing. The Velcro is very strong. Comparing this to my old GEX, I could get more work done in shorter time.

Coming back to my daily drive, I sealed it with Finish Kare Hi-Temp Paste Wax (1000P).

And now for some shinning gallery.

More posts coming up.
Happy detailing.

1 comment:

  1. thnx for the review. Planning to buy one for me as well.